Acrylic copolymer based liquid plastic coating and isolation material.
Areas of Use: WATER SOLUTIONS is successfully applicable on interior and exterior walls of the buildings, columns, foundations and roofs, an in all other plaster, brick, tile, ytong constructions, vertical and horizontal surfaces, eaves, rain pipes, filters, and chimney bases where water and moisture penetration is not desired.
Drying Period (20°C) First Drying: 12 hours Final Drying: 24 hours
Specifications: WATER SOLUTIONS is entirely water-proof. Easily applicable due to its semi-liquid structure. Therefore, even hardest surfaces can be covered with this substance. It is elastic. Excellent sticking process on all kinds of construction material. Maintains its elastic characteristics against hot and could changes.. Resistant to weak chemicals and ultra-violet rays. Enables respiration of the surfaces. Decorative. Produced in white color. In open places, it can be tested after 48 hours. Application: The surfaces subject to WATER SOLUTIONS application must be durable and free from all kinds of dirt, oil and dust. WATER SOLUTIONS must particularly be applied between +5°C and 35°C temperature during the dry weathers. WATER SOLUTIONS is applied as single layer 100% thinning with water, and if as second layer is required, it is directly applicable without thinning according to the condition of the surface. 24 hours should pass between the application of layers.
R 22: It is harmful to health if swallowed. Safety warnings: S 2: Keep out of reach of children. S 3/7: Keep the pot in a cool place having its cap closed. 5 24/25: Avoid contact with eyes and skin. 5 29: Do not discharge to sewerage system. S 46: If swollen, seek medical advice immediately, and show the pot or the label.
First 24 hours after the application (until the final drying is complete) WATER SOLUTIONS the surface must be protected 24 hours from rain,snow and freezing. Thinning (Volume) In the first layer coating, it should be thinned 100% with water. Test Drying: 48 hours Coverage Depending on the application and the surface, for single layer, 1 litre will be enough to cover the 1-2 m2.
Applied to the surfaces subjected to a priming process in 2 coats by diluting with maximum 10% water by a roller or brush. The waiting time between the coats is 5-6 hours (may vary depending on the ambient temperature). Application temperature should be between 5°C and 35°C.
